I was not paying attention this morning and did not properly get the steel sheet bed down on the printer, it was propped up on the metal screw in the back. This caused me to slam the print head into the steel sheet not once but twice leaving some nice scratches in the steel. I didnt realize how much damage I had done until the printer would not work properly and when I started diagnositcs it had shoved the PINDA sensor completely out of place. Once I finished the XYZ calibration and started the 1st layer calibration I am getting a lot of pull off from the bed. There is a really good chance that I deformed the print nozzle of the printer. Sooooo.... I am ordering new parts from Prusa today but it could be a week or more before any more parts come off this printer :/
Comments