Saved me a shitload of time... Money? Well.... It's great being single cause I do not have to apologize for my spending habits :P. So much for the excuse that this would be a relatively cheap build. Anyway, I cut the map into 58 bit size pieces about 8x10" and then printed them at 205% in grey scale. Damn near burned through a 100+' roll of paper and a black cartridge. The pieces are tacked down at the corners with a glue stick. I am really happy with how close the printout came to what I wanted. The only issue was my grid on the table was 1" too high so the pieces do not line up perfectly with the table grid. No matter, most of that will be covered in terrain shortly.
top of page
Search
Post: Blog2_Post
bottom of page
Comments