God these molds look horrible. Like the skin of some ancient mummy!! Hopefully I can put them to some good use.

Sorry for the post delay. Designing, printing and deploying the dock area of waterdeep.

Ok, so the buildings are not going to be vertical. They are going to tilt with the elevation of the ground. It is just going to be too...

Trying to get a basic surface on the pier. I think it is vital to make it look sort of like planks. May have to break down and learn...

Hi Everyone. Been trying to learn resin printing and coming up against this error when trying to print multiple items. Apparently I...

Only kind of Resin I am used to is from my teenage years. Oh well, live and learn new stuff. So, I got a resin printer and promptly...

Yeah, I am gonna keep my day job. However, yesterday was really productive. Got both the troll tower and the troll fort designed and...

In Early August I could barely model a cube. Not gonna say that my models do not need repair or that my poop doesnt stink but I am...

The buildings for East Harbor have been completed. I had hoped to get to this point by the end of the month and arrived a bit early. ...

40 buildings permanently placed, 80+ more in the painting stage. Taking some morning shots. Not happy with the number of brick...

Ok, so I designed and printed over 70 generic buildings related to the East Harbor neighborhood in the dock ward and then I also managed...

Ok Threw in a needle with some paper stuck through it and it makes a passable sail. Now just need to figure out how to paint stainless...

Cockaroaches??? We dont need no stinking Cockaroaches!! When these are at 25mm scale you can use dowel rods and bits of paper to...

It is hard to photograph these pieces in a way that shows off the level of detail. These are parts of a printable scenery galleon taken...

Sorry for the poor quality. Excited to get a set of rollers but it did not improve the condition of my shitty $30.00 tripod. Not meant...

Got an Anycubic Photon last week. Been hesitant to get it going, not sure why. The first print failed and did not stick to the bed. I...